Rodgers PR-300S Owner's Manual page 25

A B
T
T
*Press [STOP] to stop playback of the repeated
I I
section.
14 15 16 17 18 19
20
To Clear a Marker:
• •
A-MARKER-B
-~
MARKER
CLEAR
~
This would clear marker B.
Repeated Section
* A marker must be cleared before it can be moved to
another location.
(2)
Press marker you wish to clear.
(1) Hold [MARKER CLEAR], and,
•
REPEAT
-
•
III
Pressing [REPEAT] returns the PR-300S to the beginning
of the section to be repeated (the location of Marker A). In
this case, the PR-300S returns to the start of measure 15.
17
The PR-300S will play the section you've marked
(between the beginning of measure 15 and the
beginning of measure 19) over and over again.
The PR-300S will go back to the beginning of the
repeated section - - - in this case, the start of
measure 15.
*When the Repeat function is activated, you will
only be able to select measures within the section
specified by Marker A and Marker B. In the
example we've been using, you will be able to
select only measures 15 - 19 with the [FWD] and
[BWD] keys. In addition, pressing [RESET] will
return you to the beginning of measure 15, where
Marker A is sel.
If you cancel the Repeat function by pressing the
[REPEAT] button again, you wi II be able to select
any measure within the sequence and pressing the
RESET button win return you to the beginning of
the sequence.
*Pressing a marker button which has been set will
move you to the marker's location in the sequence.
* If Marker A is not set and the Repeat function is
activated, the PR-300S will use the beginning of
the sequence as the beginning boundary of the
repeated section.
* If Marker B is not set and the Repeat function is
activated, the PR-300S will use the end of the
sequence as the ending boundary of the repeated
section.
*
If the Repeat function is activated and no markers
are set, the entire sequence will be repeated over
and over.
(5) Press [REPEAT] so that its light comes on.
(6)
Press [PLAY].