Rodgers PR-300S Owner's Manual page 141

Address
Size (Hl Data (Hl
Parameter Description
41 m6
IT
00 00 01 00 - 7F CHORUS SEND LEVEL 0.0 - 1.0
Multiplicand of the part chorus depth
(=8n 63 IE 62 rr 06 vv)
41 m7 rr 00 00 01
00 - 01
Rx. NOTEOFF OFF/ON
41 m8 rr 00 00 01 00 - 01 Rx. NOTEON OFF/ON
When you change Drum Sets. all values of the DRUM SETUP PARAMETERS will be initialized.
• Bulk Dump
You can send or request bulk data which contains a large amount of parameter data by using Bulk Dump communication. It is used for storing bulk
data in a sequencer or a computer.
To send or request bulk data, use the Address and Size indicated in the following map.
You cannot use any address having"'" for
the
lOP
address in a System Exclusive message except in the following case: If you send messages which
include large amounts of data (more than 128 bytes) and you send them out in separate packets, then, the top address of the following messages may
have an address marked "#".
When sending several packets of large DT I messages. insert intervals of at least 40ms in between each packet.
OAII Parameters
(System Parameters and all Patch Parameters)
Address (Hl Size (Hl Description Number of packets
48 00 00 00 ID 10
# ALL
30 packets
48 1D OF#
•
OSystem Parameters
•
Address (Hl Size (Hl Description Number of packets
•
48 00 00 00 00 10
# SYSTEM PARAMETERS I packet
•
48 00 OF#
•
•
OPatch Parameters
•
Address (Hl Size (Hl Description Number of packets
•
48 00 10 00 10 00
# PATCH COMMON I packet
• 48 01 OF#
•
48 01 10 00 01 60
•
# BLOCK 0 2 packets
48 02 6F#
•
•
48 02 70 00 01 60
# BLOCK 1
2 packets
•
48 04 4F#
•
48 04 50 00 01 60
•
# BLOCK 2
48 06 2F#
•
48 06 30 00 01 60
•
# BLOCK 3
2 packets
•
48 08 OF#
•
133
•