Saving A Song To A Different Name (Save As) - Rodgers PR-300S Owner's Manual

(3) Press [ENTER] to save the song.
The PR-300S will save the song to the disk. To
stop the save procedure, press [STOP].
Saving a Song to a Different Name (SAVE AS)
You can use the Save As function to save a version
of a song to another song number (and different name,
if you wish).
To perform a Save As:
(1)
Insert a formatted 3.5" disk into the PR-300S's
disk drive.
Make sure the disk's Write Protect Tab is set to
"Write", not "Locked". If you haven't formatted
your disk on the PR-300S yet, see "Formatting a
Disk" later in this section.
(2)
Hold [SHIFT] and press [SAVE AS].
This button is located underneath the top cover.
(3) Rotare the alpha-dial to sele.ct the desired song
number.
If you select the song number of an existing song,
then the song you are saving will replace the
existing song. A "#" after the song number
indicates that the selected song is the original
version of the song you are saving.
TRANSPOSE
SAVE
- -
(1)
SAr)
Indicates you will overwrite
the original song.
If you don't want to erase anything on disk by
writing over it, rotate the alpha dial and select a
song number which has no song saved to it. Any
song number between I and 99 can be selected.
(4) Press the [>] button to move the cursor to the
second line, and name the song, if desired.
You don't have to name the song if you don't want
to. If you don't name the song to be saved, then it
will be represented by the song number only.
If you do want to name the song, use the [<] button,
[>] button and alpha-dial to name your song. The
name can be up to 12 characters in length and can
use any combination of upper case, lower case and
special characters available.
89
-
..
Changes
Character
:::::
-
..
Moves
Right
-
.....
Moves
Left