Rodgers PR-300S Owner's Manual page 37

(2) Rotate the alpha-dial until "MIDI Clock Out"
appears in the display.
If the display reads "MIDI Clock Out : On", then
the PR-300S is set correctly and you should press
[ENTER] to return to the Play Screen.
If the display reads "MIDI Clock Out : Off', then
go to step 3.
(3) Press [TEMPO] to move the
n
l '
prompt.
(4) Rotate the alpha-dial to change "Off" to "On".
This will tell the PR-300S to send its clock
messages to the Rodgers organ.
(5) Press [ENTER].
Now that the PR-300S is transmitting clock
messages, use the following procedure to record a
single pass sequence:
•
TEMPO
J= -
~
•
TRANSPOSE
i' : ' i I [) I
If this field is set to "On", press
[ENTER]. If it is set to "Off",
press [TEMPO] and rotate the
alpha-dial to select "On". Then,
press [ENTER].
(1)
If not already selected, press [SONG] and rotate
alpha-dial so that "NEW SONG" is listed in the
display.
This clears any song information which may still be
in the PR-300S's memory.
If there is an unsaved performance in the PR-300S's
memory, then it will ask you if it is okay to erase
the song data. (An unsaved performance is
designated with an asterisk ("*").
If you would like to save the song data, press
[STOP] and save performance (see "Saving a
Sequence to Disk").
(2) Select the desired organ registrations and PR-
300S sounds and store them into a combination
piston. Press General Cancel on the organ.
29
SONG
1mJ
I
If necessary, press [SONG] and rotate the alpha-
dial until "NEW SONG" appears in the display.