Rodgers PR-300S Owner's Manual page 72

(5) When you're finished playing, press [STOP].
(6) Hold down [SHIFT] (inside the lid) and press
[ENTER] again to cancel the Minus One
function and return to the Play screen.
To adjust the volume of the Minus One Part...
Instead of having the Minus One Part muted
completely, you can use this procedure to raise the
volume to the desired level. Doing so can allow
you to use the Part as a guide for your own real
time performance.
(1)
Hold down [STOP] and press [SOUND] (inside
the lid).
(2) Use the alpha-dial to select "-1 Part Vol".
(3) Use [>] to move the cursor and then use the
alpha-dial to set the Minus One Part volume.
If you set this level to 50% for example, the Minus
One Part will be heard at 50% of its original
volume. In the normal Minus One situation, the
volume for the selected Part would be 0%.
(4) Press [ENTER].
The PR-300S will return to the Play screen.
• If you use a connected MIDI instrument to play the PR·300S's
internal sound source and try Minus One play, you should set
the volume level to 0%. If the Minus One Part is at any setting
other than 0%. then the volume of the Part you're playing will
change at the same time as the volume level for the muted Part.
• When the Solo function is used after setting the Minus One
Part volume, the Solo Part is played at its original volume level,
and the other Parts are played at levels proportionate to the
Minus One Part volume.
64
SOUND
-
c1
-
~
•
t
• •
C
C
• •
• •
, .
• •
• •
• •
•
C
• •
• •
• •
• •
•
t