Saving Program Changes - Rodgers PR-300S Owner's Manual

(3) Press
Low
D on the bottom manual of the organ
to send program change 3 to the PR-300S.
GREAT (2 manual organs)
CHOIR (3 manual organs)
This number is changed from "7" for
"Harpsichord" to "3" for "Piano 3"
•
(
(
•
(.
r
r
l.
,..
• •
• •
• •
•
(
• •
• •
• •
• •
•
(
• •
(
(
t
(
(
.n:,
........
.....
1
Send Program Changes to
Select PR-300S Sounds
To store Program Changes for PR-300S into
organ's combination action ....
24
Once you have sent a Program Change to select a
PR-300S sound, you can save that Program Change
message into the combination action of the organ
so that the sound will be selected when you press a
piston.
A chart showing all of the program changes which
can be sent from your Rodgers organ is included
with tois manual. This chart has also been cross-
referenced to show which sounds in the PR-300S
will be selected when each program change is sent.
To store a program change into the combination
action of the organ, follow these steps:
You may send program changes for any MIDI
coupler on your organ, as long as it transmits on
MIDI channels 1-10. Also, any combination of
available couplers can be used.
To check and make sure "Piano 3" was selected,
press [SOUND] and select Part I. "Piano 3" should
appear in the display.
Note: Refer to your organ's user manual for more
specific information on using other MIDI couplers.
The PR-300S's "Piano 3" voice will be selected and
will play when notes are pressed on the Great
manual.
You can use other MIDI couplers on your Rodgers
organ to select and play sounds in the PR-300S.
Simply hold [SET] and press the desired MIDI
coupler, then press a key which corresponds to the
sound you wish to select.
*Pressing Low D while the MIDI ON GREAT
piston was Hashing sent Program Change #3. If
you had pressed Low C, Program Change #1 would
have been sent. Low C# would have sent Program
Change #2, Low D# would have sent Program
Change #4, etc.
(1) Send program changes for desired MIDI
couplers to select sounds on the PR·300S.
Saving Program Changes