Changing The Bend Range Of A Part; Muting A Part; Executing Settings For The Parts - Rodgers PR-300S Owner's Manual

TRANSPOSE
WRITE
-
TUNE
~
ENTER
~
Play Screen
Settings executed
(permanent)
TRANSPOSE
I
!.:h"· },
t.
i : ::' ~)
l) j....
i::/?
!
!
/
Play Screen
Settings executed
(temporary)
-
-
53
Pressing [WRlTE] or {ENTER] then [ENTER] will
cause all settings (except for Bend Range) to
become permanent. These changes will be retained
when the song is saved to disk.
Returning to the beginning of a song by pressing
[RESET] or [BWD] will cause the original settings
to return.
Many keyboards have pitch bend wheels or other
devices which allow you to smoothly change the
pitch of a note. This seuing allows you to
determine the amount of pitch bend which can
occur when the pitch beRd wheel is at its
maximum.
To mute any part, first press {SOUND] (inside the
lid) to select the Sound screen. Press the I>] bUllon
as necessary to select the Mute screen. Rotate the
alpha-dial to select the part you wish to mute. Press
the [>] bullon once again to select "Mu!:". Use the
alpha-dial to mute (On) or unmute (Off) the
selected part.
If you press [STOP] the PR-300S will return to the
Play Screen and all changes you've made will be
stored temporarily. The temporary settings will not
be saved when you save the song to a disk.
Pressing [WRlTE] or {ENTER] then [STOP] will
cause all settings to be temporary.
After you've made all desired changes in the Sound
Function, you can execute these settings in two
different ways.
(9) Press the [>] button to move the cursor to
"Bend:". Rotating the alpha-dial will change
the amount of pitch bend which can occur
for
the selected Part. The range is from 0 seraitones
to 24 semitones.
Muting a Part
Changing the Bend Range of a Part
Executing the Settings for the Pacts