Using The Repeat Play Function - Rodgers PR-300S Owner's Manual

Select measure 15 in the display
Select measure 19 in the display
I
£
(
• •
C
• •
• •
•
f A
• •
• •
• •
•
(
• •
• •
• •
• •
•
C
r
•
L
•
~
4-
4-
Press [MARKER B] to set end
of repeated section at the start
of measure 19.
Press [MARKER A] to set
beginning of repeated section
at the start of measure 15.
• 0
A-MARKER-B
~-
• •
A-MARKER-B
-~
BWD FWD
11:II1:=1I
BWD FWD
11:II1:=1I
SONG
lC0
I
-
l{)
(3) Use the [FWD] and [nWD] keys to go to
measure 19.
(1)
Use the [FWD] and [BWD] keys to go to
measure 15.
This sets the ending boundary of the repeated
section at the start of measure 19.
(4) Press [MARKER B] so that its light comes on.
In this example, we'll use the demo song we've
used before, "Mozart K-336". Select this song (if
it's not already selected) by pressing the [SONG]
button and rotating the alpha-dial.
(2) Press [MARKER A] so that its light comes on.
Using the Repeat Play Function
This sets the beginning boundary of the repeated
section at the start of measure 15.
With the Repeat Play function, you can set Markers at
the beginning and end of a particular section of music
and instruct the PR-300S to repeat that section over
and over again.
The PR-300S Markers set the boundaries for the Repeat Play
function. The two marker buttons (labeled "MARKER A" and
"MARKER B") are located on the left side of the unit near the
power switch. Marker A is used to set the beginning boundary
of the repeated section; Marker B is used to set the ending
boundary.