Rodgers PR-300S Owner's Manual page 40

e
TEMPO BEAT
J=
I
- -
~
....
Changes
Moves Moves
Character Right Left
TRANSPOSE
recalled and played at any time.
To save a sequence to disk, follow this procedure:
(1)
Insert a formatted PR-300S disk into the disk
drive.
If you haven't yet formatted the floppy disk you
want to use, follow the procedure, "Formatting a
Disk", found later in this manual.
(2) Press [SAVE].
This button is located underneath the access panel.
A screen will appear which has a number followed
by a blank line, i.e., "I ". If the name
of a previously recorded song appears, rotate the
alpha-dial until you get a screen with nothing other
than a number in the upper left hand corner.
(3) Press [TEMPO] to move the
lJo
prompt to the
second line.
The PR-300S is now ready for you to give a name
to the song. The name can be up to 12 characters in
length and can use any combination of letters,
numbers and symbols available.
(4) Use the alpha-dial, BEAT button and TEMPO
button to name your song.
To find a character, rotate the alpha-dial.
To move to the right, press the [TEMPO] button.
To move to the left, press the [BEAT] button.
(5) Press [ENTER] once.
The PR-300S will ask you if you are sure you want
to save the song.
(6) Press [ENTER] again to save song.
While the song is saving, the disk light will be
brightly illuminated and the display will read
"Please Wait ...".
Do not attempt to eject the disk while the disk light
32
SAVE
-
S AVE AS
TEMPO
J= -
~
1
~~: ......
After pressing [SAVE], press [TEMPO] to
move to the second line. Then use the
alpha-dial, TEMPO button and BEAT button
to name your sequence.
TRANSPOSE
is bright, or you may damage the disk beyond
repair!
When the song is finished saving, the display will
return to the Play Screen. You may eject the disk
and power off the PR-300S.
To load the disk and listen to the sequence again,
•
•
(
• •
(
C
•
4 :
C
•
r
• •
• •
• •
•
C
• •
• •
• •
• •
(
(
,.
,
C
•
C
L
(