FRONT BEARING CARRIER
INSTALLATION
1. Install drive shaft axle through the backside of the
bearing carrier.
2. Install the upper and lower ball joint ends into the
front bearing carrier.
q
3. Install pinch bolts
and nuts. Torque to specification.
TORQUE
Ball Joint Pinch Bolts:
44 ft-lbs (60 Nm)
4. Apply Anti-Seize to drive shaft axle splines.
5. Install front wheel hub assembly
and hand tighten the castle nut. Install washers with
domed side out.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
6. Install new brake caliper mounting bolts and torque to
specification.
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
7. Install the steering tie rod end
bearing carrier.
w
e
, cone washer
,
8. Torque the tie rod end fastener
FINAL DRIVE
TORQUE
Front Caliper Mounting Bolts:
33 ft-lbs (45 Nm)
CAUTION
mounting bolts upon assembly.
r
onto the front
t
to specification.
TORQUE
Tie Rod End Fastener:
30 ft-lbs (40 Nm) + 90°
8
8.5