Probe-Scsi, Probe-Scsi-All; D.1.6 Module-Info - Sun Microsystems SPARCstation 5 Model 110 Service Manual

D.1.5
probe-scsi,
The probe-scsi test sends an inquiry command to internal and external SCSI
devices connected to the system's internal SCSI interface. If a SCSI device is
connected and powered up, the target address, unit number, device type, and
manufacturer name should be displayed.
For example:
ok probe-scsi
Target 3
Unit 0 Disk SEAGATE ST1480 SUN04245828 Copyright (c) 1991 Seagate All rights
reserved.
The probe-scsi-all test sends an inquiry command to all SCSI devices on all the
SCSI host adapters installed in the system. The first identifier listed in the display is
the SCSI host adapter address in the system device tree, followed by the SCSI device
identification data.
For example:
ok probe-scsi-all
/iommu@0,100000000/sbus@0,10001000/espdma@5,8400000/esp@5,8800000
Target 1
Unit 0 Disk CONNER
Target 3
Unit 0 Disk CONNER
Target 6
Unit 0 Removable Read Only device
D.1.6
module-info
This command reports back the system CPU information including: the
microprocessor name, its revision, the speed at which it is running in megahertz,
and the SBus speed in megahertz.
For example:
ok module-info
CPU FMI,MB86904 Rev. 2.0: 70.0 Mhz
SBus (Divide By 3)
ok
probe-scsi-all
CP30548 SUN0535AEBX93081QTT
CP30548 SUN0535AEBX93081QTT
TOSHIBA CD-ROM XM-4101TA289310/16/93
: 23.3 Mhz
Appendix D FORTH Diagnostics D-7