Sun Microsystems SPARCstation 5 Model 110 Service Manual page 61

Table of Contents

Advertisement

2. Press Stop-a (or Break).
If you use a Wyse WY-50, VT-100 or compatible terminal as the console with your
SPARCstation 5 system unit, press Break instead of Stop-a.
Note – If the system does not respond to the mouse and keyboard, pressing Stop-a
will not be effective. You may have to turn the power off, wait at least 10 seconds,
and turn the power on again. Then try pressing Stop-a once more.
3. When the ok prompt appears, boot the operating system.
Enter boot at the ok prompt.
4. When you see the login prompt, log in to the system with your user name and
password.
5. Halt the operating system.
See the documentation supplied with your operating system for instructions on how
to halt it.
a. For Solaris 2.x (SunOS 5.x) systems, type:
% su
Password: superuser password
# /usr/sbin/shutdown -y -g60 -i0
b. For Solaris 1.x (SunOS 4.x) systems, type:
% su
Password: superuser password
# /usr/etc/shutdown -h +1
The operating system warns other users connected to your system from the
network of the impending shutdown, and then halts itself after a one-minute
delay. If you wish to provide a longer delay, see the man page for shutdown(1).
The system responds with system halt messages followed by the ok prompt.
When the ok prompt appears, you can safely turn off the power in the proper
sequence.
c. When the ok prompt appears, turn off the power to the system components in
this order:
1. External drive units (if you have any)
2. System unit
Chapter 6
Power On and Off
6-3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPARCstation 5 Model 110 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Sparcstation 5

Table of Contents