Metal cable clips
on chassis floor
Metal cable clips
on chassis wall
Diskette data
connector
SCSI data connector
DC power connector
FIGURE 9-15
2. Connect the SCSI data cable to the SCSI backplane.
3. Connect the DC power harness to the SCSI backplane.
4. Insert the front edge of the system board into the card guide. Lift the rear of the
board slightly and slide it along the card guide until it is fully inserted.
See
FIGURE 9-16
Internal Cable Routing
.
Speaker/LED cable
DC power harness
SCSI data cable
SCSI backplane
Card guide
cable clips
Speaker/LED
connector
CD-ROM audio
connector
Chapter 9
Storage Devices
9-17
Need help?
Do you have a question about the SPARCstation 5 Model 110 and is the answer not in the manual?