Figure 9-22 Replacing The System Board; Figure 9-23 Rear Panel Captive Screws - Sun Microsystems SPARCstation 5 Model 110 Service Manual

FIGURE 9-22
9. Reconnect the DC power, diskette data, SCSI data, speaker/LED, and the audio
cables to the system board.
See
FIGURE 9-21
chassis wall after it is plugged in to the system board.
10. Reinstall the SBus card (if necessary).
See Section 11.1.2 "Replacing an SBus Card."
11. Tighten the two captive Phillips screws that secure the board to the rear of the
chassis.
See
FIGURE 9-23
FIGURE 9-23
9-24 SPARCstation 5 Model 110 Service Manual • November 1996
Chassis wall
Replacing the System Board
. Thread the SCSI data cable through the metal cable clips on the
.
Captive screw
Rear Panel Captive Screws
Card guide
System board
Captive screw