Sun Microsystems SPARCstation 5 Model 110 Service Manual page 137

Installing the System Board
FIGURE 11-21
2. Tighten the two captive Phillips screws that secure the board to the rear of the
chassis.
See . Do not overtighten these screws.
FIGURE 11-22
System Board Captive Screws
FIGURE 11-22
3. Reconnect the DC power, SCSI data, diskette data, speaker/LED, and CD-ROM
audio cables to the system board.
See .
FIGURE 11-18
4. Take the following components that you removed from the defective system board
and install them on the new system board:
Captive screw
Chapter 11 System Board and Component Replacement
Card guide
System board
Captive screw
11-21