Probe-Scsi And Probe-Scsi-All - Sun Microsystems Ultra 60 Service Manual

CODE EXAMPLE 4-3
{0} ok watch-net-all
/pci@1f,4000/network@1,1
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet.
Type any key to stop.
...
4.6.3

probe-scsi and probe-scsi-all

probe-scsi transmits an inquiry command to internal and external SCSI devices
connected to the system unit on-board SCSI interface. If the SCSI device is connected
and active, the target address, unit number, device type, and manufacturer name is
displayed. probe-scsi-all transmits an inquiry command to SCSI devices
connected to the system SCSI host adapters. The first identifier listed in the display
is the SCSI host adapter address in the system device tree followed by the SCSI
device identification data.
CODE EXAMPLE 4-4
the probe-scsi-all output message.
CODE EXAMPLE 4-4
ok probe-scsi
Target 0
Unit 0
Target 6
Unit 0
XM5701TASUN12XCD0997
CODE EXAMPLE 4-5
{0} ok probe-scsi
Target 0
Unit 0
4-10 Sun Ultra 60 Service Manual • August 2001
watch-net-all Output Message
-- Using Onboard Transceiver - Link Up.
'X' is a Bad Packet.
identifies the probe-scsi output message and
probe-scsi Output Message
Disk QUANTUM VK4550J
Removable Read Only device
probe-scsi-all Output Message
Disk QUANTUM VK4550J
CODE EXAMPLE 4-5
SUN4.2G8600
TOSHIBA
SUN4.2G8600