Sun Microsystems SPARCstation 5 Model 110 Service Manual page 34

TABLE 2-4
Type of Test Description
Monitors broadcast Ethernet
watch-aui
packets (10BASE5—Thicknet) on
the Ethernet cable(s) connected to
the system.
Monitors broadcast Ethernet
watch-tpe
packets (10BASET—Twisted Pair
Ethernet) on the Ethernet cable(s)
connected to the system.
Monitors broadcast Ethernet
watch-net-all
packets on all Ethernet interfaces
installed in the system, one at a
time.
Returns to the display the SCSI
probe-scsi
devices (internal and external)
and their SCSI targets connected
to the built-in SCSI port.
Returns to the display the SCSI
probe-scsi-all
devices and their SCSI targets
connected to all SCSI ports (both
the built-in SCSI port and any
additional SCSI host adapter
cards).
power-off Powers off the system.
2-10 SPARCstation 5 Model 110 Service Manual • November 1996
Selected FORTH Diagnostic Tests (Continued)
Preparation
Connect the system to the
network via the desired
Ethernet port.
Connect the system to the
network via the desired
Ethernet port.
Connect the system to the
network via the desired
Ethernet port.
Connect external SCSI
devices to the system and
turn on their power.
Connect external SCSI
devices to the system and
turn on their power.
You must have a Sun Type-5
keyboard in order to use this
command.
When to Use
See description.
See description.
When an SBus card
network controller
card is installed.
To determine if a
SCSI peripheral is
talking to the
system.
To determine the
SCSI targets
(addresses) of a
SCSI device.
To determine if
more than one SCSI
peripheral is
assigned the same
SCSI address.
To determine if the
built-in SCSI
controller is
defective.
See probe-scsi.
To determine if a
SCSI host adapter
controller is
defective.
To power off the
system with a Sun
Type-5 keyboard.