Probe-Scsi And Probe-Scsi-All - Sun Microsystems Sun Ultra 60 Service Manual

watch-net Output Message
CODE EXAMPLE 4–3
{0} ok watch-net
Hme register test --- succeeded.
Internal loopback test -- succeeded.
Transceiver check -- Using Onboard Transceiver - Link Up.
passed
Using Onboard Transceiver - Link Up.
Looking for Ethernet Packets.
'.' is a Good Packet.
Type any key to stop.
...........
4.6.3

probe-scsi and probe-scsi-all

probe-scsi transmits an inquiry command to internal and external SCSI devices
connected to the system unit on-board SCSI interface. If the SCSI device is connected
and active, the target address, unit number, device type, and manufacturer name is
displayed. probe-scsi-all transmits an inquiry command to SCSI devices
connected to the system SCSI host adapters. The first identifier listed in the display is
the SCSI host adapter address in the system device tree followed by the SCSI device
identification data.
Code Example 4–4 identifies the probe-scsi-all output message and Code
Example 4–5 the probe-scsi output message.
probe-scsi-all Output Message
CODE EXAMPLE 4–4
{0} ok probe-scsi
Target 0
Unit 0 Disk
Target 6
Unit 0 Removable Read Only device
{0} ok probe-scsi-all
/pci@1f,4000/scsi@3,1
/pci@1f,4000/scsi@3
Target 0
Unit 0 Disk
Target 6
Unit 0 Removable Read Only device
'X' is a Bad Packet.
QUANTUM VK4550J SUN4.2G8600
TOSHIBA XM5701TASUN12XCD0997
QUANTUM VK4550J SUN4.2G8600
TOSHIBA XM5701TASUN12XCD0997
Troubleshooting Procedures
4-9