Replacing The Diskette Drive; Figure 9-10 Removing The Diskette Drive - Sun Microsystems SPARCstation 5 Model 110 Service Manual

FIGURE 9-10
6. Lift the diskette drive out of the chassis and place it on an antistatic mat.
9.3.2

Replacing the Diskette Drive

1. Remove the new diskette drive and its related parts from the antistatic bag, and
place them on an antistatic surface.
Read the diskette drive specifications sheet for related installation information.
2. Hold the diskette drive in one hand, and lower it far enough into the chassis to
connect the cables to the back of the drive.
3. Attach the diskette data cable and the DC power cable (labeled P4) to the drive
connectors.
See
FIGURE 9-11
4. Lower the drive grommets into their corresponding slots in the side rails, and
slide the drive until it is fully secured in the bracket.
See
FIGURE 9-11
9-12 SPARCstation 5 Model 110 Service Manual • November 1996
Removing the Diskette Drive
.
.