Replacing A Dsimm; Figure 11-16 Orienting A Dsimm - Sun Microsystems SPARCstation 5 Model 110 Service Manual

11.3.2

Replacing a DSIMM

1. Carefully remove the new DSIMM from its protective packaging and place it on
an antistatic surface.
2. Choose any available slot and unlock (press down) the ejector levers at both ends
of the connector.
3. Align the DSIMM with the slot.
See
FIGURE 11-16
at the bottom of the DSIMM line up with the two tabs in the DSIMM connector.
Note – Slot J0300 (the one closest to the rear panel) must always contain a DSIMM.
If you combine different capacity DSIMMs in the same system, this slot must contain
the highest-capacity DSIMM.
FIGURE 11-16
4. Place your thumbs as shown in
connector.
5. To lock the DSIMM in place, lift up both ejector levers.
11-16 SPARCstation 5 Model 110 Service Manual • November 1996
. Hold the DSIMM by its edges and orient it so that the two notches
Orienting a DSIMM
and push the DSIMM firmly into its
FIGURE 11-17
Align notches with
corresponding
tabs in DSIMM
connector.