Disassembling And Assembling; Separating Front Axle [4Wd Model] - wsm M7060 Workshop Manual

M6060, M7060, WSM

[2] DISASSEMBLING AND ASSEMBLING

(1) Separating Front Axle [4WD Model]

Adjusting Front Axle Pivot
1. Jack up the tractor body, then loosen the front axle rocking force
adjusting lock nut (2).
2. Screw in the adjusting screw (1) until seated, then tighten the
adjusting screw (1) with an additional 1/6 turn.
3. Retighten the lock nut (2).
Front axle rocking force
adjusting screw
Tightening torque
Front axle rocking force
adjusting lock nut
(1) Adjusting Screw
Adjusting between Bevel Gear Case and Stopper [4WD Model]
1. Inflate the tires to the specified pressure.
2. Steer the wheels to the extreme right until the knuckle arm (1)
contacts with the bevel gear case (2).
3. If the knuckle arm (1) can not be contacted with the bevel gear
case (2), shorten the length of stopper (3).
4. Keeping the knuckle arm (1) contact with the bevel gear case
(2), make a specified length as shown in the table.
5. After adjustment, secure the stopper with the lock nut (4).
6. For adjusting the left steering angle, perform the same
procedure as mentioned in right steering angle.
Clearance between
bevel gear case and Factory specification
stopper (L)
(1) Knuckle Arm
(2) Bevel Gear Case
(3) Stopper
(4) Lock Nut
(5) Front Gear Case
Draining Front Axle Gear Case (Right and Left) and Front
Differential Case Oil
• See page G-37.
5-S6
FRONT AXLE
20 to 29 N·m
2.0 to 3.0 kgf·m
15 to 21 lbf·ft
98.1 to 147 N·m
10.0 to 15.0 kgf·m
72.4 to 108 lbf·ft
(2) Lock Nut
9Y1210828FAS0006US0
Below
0.5 mm
0.02 in.
L : Clearance
9Y1210828FAS0007US0
9Y1210828FAS0008US0
KiSC issued 08, 2013 A