M6060, M7060, WSM
(2) Setting Mode
• Input the various data to RAM.
• There are three different setting modes: "PTO speed display mode switching", "entering the traveling speed
coefficient" and "model select mode".
PTO Speed Display Mode Switching
-1
[With 540/540E min
(rpm) model]
The PTO speed display mode has been factory-set at Code 4. Do not try to change the code. Otherwise the
correct PTO speed will not be displayed in the LCD monitor.
-1
[With 540/1000 min
(rpm) model]
The PTO speed display mode has been factory-set at Code 5. Do not try to change the code. Otherwise the
correct PTO speed will not be displayed in the LCD monitor.
[With Shiftable PTO (540 / 1000 min
Whenever the PTO speed is changed to the other speed, it is necessary to switch the PTO speed display mode.
Otherwise the PTO speed will not get correctly displayed in the LCD monitor. When the PTO speed is changed from
-1
540 to 1000 min
(rpm) or from 1000 to 540 min
(3) Testing Mode
This tractor has "Testing mode" as shown the below table.
In the testing mode, there are 11 contents.
No.
1
Accelerator Sensor (main)
2
Accelerator Sensor (sub)
3
Engine Revolution
4
Shuttle Revolution
5
Engine Coolant Temperature
6
Fuel Empty Sensor Voltage
7
Battery Voltage
8
PTO Revolution
9
PM Sedimentation Quantity 1
10
PM Sedimentation Quantity 2
11
Fuel Quantity After Regeneration
-1
(rpm)) model]
-1
(rpm), it is necessary to switch the PTO speed display mode.
Contents
Normal Condition
0.05 to 4.9
Voltage
0.05 to 4.9
Voltage
0 to 2650
n/min
0 to 2450
n/min
−30 to 120 °C
Celsius
(−4 to 248 °F)
Empty :107 to 112
Voltage
Full : 3 to 5
8.0 to 16.0
Voltage
0 to 1000
n/min
Level1: 21
Level3: 26
Gram
Level4: 31
Level5: 36
Level1: 21
Level3: 26
Gram
Level4: 31
Level5: 36
MAX 200
L
8-M24
ELECTRICAL SYSTEM
9Y1210828ELM0008US0
Unit
Remark
Main (1) + sub (2)
3.85 V to 6.15 V
(Normal Condition)
Fuel Tank Sensor
DPF Regeneration
Request trigger 1
DPF Regeneration
Request trigger 2
DPF Regeneration
Request trigger 3
9Y1210828ELM0009US0
KiSC issued 08, 2013 A