wsm M7060 Workshop Manual page 72

M6060, M7060, WSM
Replacing Light Bulb
CAUTION
• Be careful not to drop the bulb, hit anything against the
lamp, apply excess force, and get the lamp scratched. If
broken, glass may cause injury. Pay more attention to
halogen lamps in particular, which have high pressure
inside.
• Before replacing the lamp, be sure to turn off the light and
wait until the bulb cools down, otherwise, you may get
burned.
 Head lights
1. While pushing the right and left lock buttons (2), pull and remove
the electrical connector (1).
2. Remove the rubber boot (3).
3. Remove the clamping fixture (4) and the bulb (5).
4. Replace with a new bulb and reinstall the head lamp assembly
in the reverse order.
 Other lights
1. Remove the lens and replace the bulb.
IMPORTANT
• Be sure to use a new bulb of the specified wattage.
• Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
Light
Head lights
Hazard lights (ROPS)
Hazard lights (CABIN)
Turn signal
Brake stop light / Tail light
Work light (if equipped)
Front work light
Work light (for outer roof)
Dome light (Room lamp)
Front position light
License plate light
(1) Electrical Connector
(2) Lock Button
(3) Rubber Boot
(4) Clamping Fixture
(5) Bulb
Lubricating Points (CABIN Model)
(1) Door Hinge
G-49
Capacity
12V , 55 / 60 W (H4)
12 V, 23 W
12 V, 21 W
12 V, 21 W
12 V, 5 W
12 V, 35 W
12 V, 21 W
12 V, 55 W CABIN Model
12 V, 5 W CABIN Model
12 V, 10 W
12 V, 10 W
(A) Base's wider projection to face
upward
9Y1210828GEG0077US0
(2) Rear Window Hinge
9Y1210828GEG0078US0
KiSC issued 08, 2013 A
GENERAL
Remark