wsm M7060 Workshop Manual page 530

M6060, M7060, WSM
Throttle Sensor Resistance
1. Measure the resistance between terminal A and D while slowly
turning the sensor shaft (1).
2. Then, check resistance between terminal B and D while slowly
turning the sensor shaft (1).
3. It is OK if the resistance value is approximate to the value shown
in the table below.
(Reference)
• The change of resistance can be checking easily when an
analog tester is employed.
Terminal A – Terminal D
Resistance
Terminal B – Terminal D
(1) Sensor Shaft
8-S21
ELECTRICAL SYSTEM
0 to 1 kΩ
0 to 1 kΩ
A: Terminal A
B: Terminal B
C: Terminal C
D: Terminal D
9Y1210828ELS0036US0
KiSC issued 08, 2013 A