wsm M7060 Workshop Manual page 227

M6060, M7060, WSM
Oil Clearance of Balancer Shaft Journal
1. Measure the balancer shaft journal O.D. with an outside
micrometer.
2. Measure the cylinder block bore I.D. (A), (B) for balancer shaft
with an inside micrometer.
3. If the clearance exceeds the allowable limit, replace the
balancer shaft bearing. If it still exceeds the allowable limit,
replace also the balancer shaft.
Factory specification
Oil clearance of balancer
shaft 1 journal
Allowable limit
Balancer shaft 1 journal
Factory specification
O.D.
Balancer shaft 1 bearing
Factory specification
I.D. (A)
Factory specification
Oil clearance of balancer
shaft 2 journal
Allowable limit
Balancer shaft 2 journal
Factory specification
O.D.
Balancer shaft 2 bearing
Factory specification
I.D. (B)
(1) Balancer Shaft 1
(2) Balancer Shaft 2
1-S66
ENGINE
0.060 to 0.146 mm
0.0024 to 0.0057 in.
0.2 mm
0.0079 in.
48.934 to 48.950 mm
1.9265 to 1.9272 in.
49.010 to 49.080 mm
1.9295 to 1.9323 in.
0.050 to 0.136 mm
0.0020 to 0.0054 in.
0.2 mm
0.0079 in.
48.934 to 48.950 mm
1.9265 to 1.9272 in.
49.000 to 49.070 mm
1.9291 to 1.9319 in.
(A) Balancer Shaft 1 Bearing I.D.
(B) Balancer Shaft 2 Bearing I.D.
9Y1210828ENS0103US0
KiSC issued 08, 2013 A