wsm M7060 Workshop Manual page 544

M6060, M7060, WSM
Shuttle Neutral Switch
1) Shuttle Neutral Switch Continuity
1. Check the continuity with an ohmmeter across the switch
terminals.
2. If it does not conduct or any value is indicated when the switch
is pushed, the switch is faulty.
3. If infinity is not indicated when the switch is released, the switch
is faulty.
NOTE
• Be sure to check the position of shuttle spool (2), the mark
(3) toward the outside as shown photo.
If the shuttle spool (2) is not correct position, shuttle
neutral switch (1) operates improperly.
Resistance
Reference
(Across switch
value
terminals)
(1) Shuttle Neutral Switch
(2) Shuttle Spool
(3) Mark
Foot Brake Switch
1) Wiring Harness
1. Disconnect the leads from the foot brake switch (1).
2. Connect the wiring harness lead terminals to each other and
turn the main switch ON.
3. If the stop lights do not light, the fuse, wiring harness or bulb is
faulty.
2) Brake Switch Continuity
1. Remove the foot brake switch (1).
2. Check the continuity with an ohmmeter across the switch
terminals.
3. If it does not conduct or any value is indicated when the switch
is released, the switch is faulty.
4. If infinity is not indicated when the switch is pushed, the switch
is faulty.
Resistance
Reference
(Across switch
value
terminals)
(1) Foot Brake Switch
8-S35
ELECTRICAL SYSTEM
When switch is pushed "P" 0 Ω
When switch is released
Infinity
"R"
P: Pushed
R: Released
9Y1210828ELS0057US0
When switch is pushed Infinity
When switch is released 0 Ω
P: Pushed
R: Released
9Y1210828ELS0058US0
KiSC issued 08, 2013 A