Front Wiper Switch; Front Wiper Motor - wsm M7060 Workshop Manual

M6060, M7060, WSM

(11) Front Wiper Switch

(12) Front Wiper Motor

Connector Voltage
1. Disconnect the 6P connector from front wiper switch (1).
2. Turn the main switch to "ON" position.
3. Measure the voltage with a voltmeter across the connector
terminal e of wiring harness side and chassis.
4. If the voltage differs from the battery voltage, the wiring harness,
fuse or main switch is faulty.
Voltage Terminal e – Chassis
(1) Front Wiper Switch
(2) 6P Connector (Switch Side)
Front Wiper Switch Checking
1. Check the continuity through the switch with an ohmmeter.
2. If continuity specified below is not indicated, the switch is faulty.
(1) 6P Connector (Switch Side)
Front Wiper Motor
1. Raise up the front wiper arm (3).
2. Turn the main switch to "ON" position.
3. Push the front wiper switch to "ON" position.
4. Count the number of wiper arm rocking per minutes.
5. If the number differs from the factory specifications, replace the
wiper motor assembly.
No. of wiper arm swing
Factory specification
frequency at no load
(1) Wiper Blade
(2) Wiper Motor
9-S32
Approx. battery voltage
(3) 6P Connector (Wire Harness Side)
9Y1210828CAS0052US0
9Y1210828CAS0053US0
25 to 43 times/min.
(3) Wiper Arm
9Y1210828CAS0054US0
KiSC issued 08, 2013 A
CABIN