wsm M7060 Workshop Manual page 284

M6060, M7060, WSM
Adjusting Accelerator Wire (CABIN Model)
1. Apply grease to the bushes (1) with accelerator pedal (2).
2. When touching the accelerator pedal (2) to the bolt (5), adjust
length of bolt "L2", so that the accelerator sensor lever (3)
touches link pin (4).
3. Touch the accelerator pedal (2) to bolt (5), and fix the wire
retaining nuts (8) to be a length (L1) between center of wire end
(6) and center of accelerator pedal pin (7) as shown photo.
Accelerator wire length
Factory specification
"L1"
Length of bolt "L2" Reference value
(1) Bush
(2) Accelerator Pedal
(3) Accelerator Sensor Lever
(4) Link Pin
2-S21
TRANSMISSION
0 to 5 mm
0 to 0.1 in.
55 mm
2.2 in.
(5) Bolt
(6) Wire End
(7) Accelerator Pedal Pin
(8) Wire Retaining Nut
9Y1210828TRS0016US0
KiSC issued 08, 2013 A