wsm M7060 Workshop Manual page 204

M6060, M7060, WSM
Supply Pump Gear and Crankshaft Position Pulsar Gear (If
necessary)
1. Remove the supply pump gear (1) and crankshaft position
pulsar gear (4) with gear puller (2) from the supply pump (3).
2. Remove the mounting screws of crankshaft position pulsar gear
(4).
3. Remove the crankshaft position pulsar gear (4).
(When reassembling)
• Install the crankshaft position pulsar gear (4) to the supply pump
gear (1).
• Align each pitch (a) and (b) of the crankshaft position pulsar
gear (4) and the supply pump gear (1)
Mounting screw of
Tightening torque crankshaft position pulsar
gear
(1) Supply Pump Gear
(2) Gear Puller
(3) Supply Pump
(4) Crankshaft Position Pulsar Gear
(5) Supply Pump Gear Mounting Nut
1-S43
ENGINE
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(a) Large Pitch
(b) Small Pitch
9Y1210828ENS0060US0
KiSC issued 08, 2013 A