wsm M7060 Workshop Manual page 186

M6060, M7060, WSM
Fuel Hose and Oil Cooler Pipe
1. Disconnect the fuel hoses (1).
2. Disconnect the oil cooler pipes (2).
3. Remove the oil cooler pipe mounting stay (3).
(1) Fuel Hose
(2) Oil Cooler Pipe
Separating Engine from Clutch Housing
1. Support the engine for separating from the clutch housing.
2. Remove the engine mounting screws and nut (1), and separate
the engine from the clutch housing.
NOTE
• When you replace the engine with a new one, please record
the serial number of new engine and the parts number and
serial number of "DPF Full Assembly" which is incorporate
with its new engine.
(When reassembling)
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of damper disk boss.
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the engine and clutch housing.
Engine and clutch housing
Tightening torque mounting screw and nut
(M14, 7T)
(1) Engine Mounting Screw and Nut
1-S25
ENGINE
(3) Oil Cooler Pipe Mounting Stay
9Y1210828ENS0029US0
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
9Y1210828ENS0030US0
KiSC issued 08, 2013 A