wsm M7060 Workshop Manual page 194

M6060, M7060, WSM
Camshaft Position Sensor
1. Remove the camshaft position sensor mounting screw.
2. Remove the camshaft position sensor (1).
(When reassembling)
• Replace the O-ring with a new one.
Camshaft position sensor
Tightening torque
mounting screw
(1) Camshaft Position Sensor
Crankshaft Position Sensor
1. Remove the crankshaft position sensor mounting screw (2).
2. Remove the crankshaft position sensor (1).
(When reassembling)
• Replace the O-ring with a new one.
IMPORTANT
• If you drop the sensor, do not reuse it.
Crankshaft position sensor
Tightening torque
mounting screw
(1) Crankshaft Position Sensor
Intake Air Temperature Sensor
1. Remove the intake air temperature sensor (1).
(When reassembling)
• Replace the gaskets with new ones.
Intake air temperature
Tightening torque
sensor
(1) Intake Air Temperature Sensor
Boost Sensor
IMPORTANT
• Be careful not to damage the sensor when removing the
hose from the boost sensor.
1. Remove the hose (3) from the boost sensor (1).
2. Remove the boost sensor mounting screw (2).
3. Remove the boost sensor (1).
(When reassembling)
• Replace the gaskets with new ones.
• If the hose is damaged, replace it with a new hose.
Boost sensor mounting
Tightening torque
screw
(1) Boost Sensor
(2) Boost Sensor Mounting Screw
1-S33
ENGINE
8.0 to 12 N·m
0.82 to 1.2 kgf·m
5.9 to 8.8 lbf·ft
9Y1210828ENS0046US0
8.0 to 12 N·m
0.82 to 1.2 kgf·m
5.9 to 8.8 lbf·ft
(2) Crankshaft Position Sensor
Mounting Screw
9Y1210828ENS0047US0
30 to 39 N·m
3.0 to 4.0 kgf·m
22 to 28 lbf·ft
9Y1210828ENS0048US0
4 to 5 N·m
0.4 to 0.6 kgf·m
3 to 4 lbf·ft
(3) Hose
9Y1210828ENS0049US0
KiSC issued 08, 2013 A