Master Cylinder - wsm M7060 Workshop Manual

M6060, M7060, WSM

(5) Master Cylinder

Brake Pipes and Master Cylinder Hoses
1. Remove the master cylinder hose (4) and cylinder return hose
(2) from the master cylinder assembly (3).
2. Remove the brake pipe R.H. (1) and L.H. (5).
Brake pipe retaining nut
Tightening torque
Master cylinder hose and
return hose retaining nut
(1) Brake Pipe R.H.
(2) Master Cylinder Return Hose
(3) Master Cylinder Assembly
Master Cylinder
1. Remove the master cylinder mounting nuts (1).
2. Remove the master cylinder assembly.
(When reassembling)
• After mounting the master cylinder assembly, be sure to bleed
air. (See page 4-S6.)
(1) Cylinder Mounting Nut
Equalizer
1. Drain the brake oil from the equalizer.
2. Secure the equalizer in a vise, remove the both plug (1) to pull
out the piston (5).
(When reassembling)
• Install the piston and plug, noting the O-ring.
Tightening torque Plug
(1) Plug
(2) Spring
(3) Washer
Master Cylinder
1. Drain the brake oil from the master cylinder assembly (4).
2. Remove the push rod (1) and boot (5) from the master cylinder.
3. Remove the internal circlip (2), and pull out the piston (6) and
return spring (9).
(When reassembling)
• Install the outlet valve, noting its direction.
• Install the piston, taking care not to damage the cylinder cup lip.
(1) Push Rod
(2) Internal Circlip
(3) Primary Cylinder Cup
(4) Master Cylinder Assembly
(5) Boot
4-S13
BRAKES
16 to 24 N·m
1.6 to 2.5 kgf·m
12 to 18 lbf·ft
23 to 27 N·m
2.3 to 2.8 kgf·m
17 to 20 lbf·ft
(4) Master Cylinder Hose
(5) Brake Pipe L.H.
9Y1210828BRS0017US0
9Y1210828BRS0018US0
98.1 to 117 N·m
10.0 to 12.0 kgf·m
72.4 to 86.7 lbf·ft
(4) O-ring
(5) Piston
(6) O-ring
9Y1210828BRS0019US0
(6) Piston
(7) Secondary Cylinder Cup
(8) Spacer (Shim)
(9) Return Spring
9Y1210828BRS0020US0
KiSC issued 08, 2013 A