wsm M7060 Workshop Manual page 225

M6060, M7060, WSM
Cam Height
1. Measure the height of the cam (2) at its highest point with an
external micrometer.
2. If the measurement is less than the allowable limit, replace the
camshaft (1).
Factory specification
Intake cam height
Allowable limit
Factory specification
Exhaust cam height
Allowable limit
(1) Camshaft
Oil Clearance between Camshaft Journal and Cylinder Block
Bore
1. Measure the camshaft journal O.D. with an external micrometer.
2. Measure the cylinder block bore I.D. for the camshaft with an
internal micrometer or a cylinder gauge.
3. Calculate the oil clearance.
4. If the oil clearance is more than the allowable limit, replace the
camshaft.
Factory specification
Oil clearance between
camshaft journal and
cylinder block bore
Allowable limit
Camshaft journal 1 O.D. Factory specification
Cylinder block bore 1 I.D. Factory specification
Camshaft journal 2 O.D. Factory specification
Cylinder block bore 2 I.D. Factory specification
(1) Camshaft Journal 1
Replacement of Camshaft Cover (If necessary)
1. Remove the used camshaft cover and clean the hole.
2. Install the new camshaft cover (1) until bumping using camshaft
cover replacing tool. (See page G-57.)
(1) Camshaft Cover
1-S64
ENGINE
37.50 mm
1.476 in.
37.00 mm
1.457 in.
37.90 mm
1.492 in.
37.40 mm
1.472 in.
(2) Cam
9Y1210828ENS0098US0
0.050 to 0.091 mm
0.0020 to 0.0035 in.
0.15 mm
0.0059 in.
34.934 to 34.950 mm
1.3754 to 1.3759 in.
35.000 to 35.025 mm
1.3780 to 1.3789 in.
43.934 to 43.950 mm
1.7297 to 1.7303 in.
44.000 to 44.025 mm
1.7323 to 1.7332 in.
(2) Camshaft Journal 2
9Y1210828ENS0099US0
9Y1210828ENS0100US0
KiSC issued 08, 2013 A