Fuse - wsm M7060 Workshop Manual

M6060, M7060, WSM

(2) Fuse

Fuse (ROPS Model)
1. The tractor electrical system is protected from potential damage
by fuses.
2. A blown fuse indicates that there is an overload or short
somewhere in the electrical system.
3. If any of the fuses should blow, replace with a new one of the
same capacity.
IMPORTANT
• Before replacing a blown fuse, determine why the fuse blew
and make any necessary repairs. Failure to follow this
procedure may result in serious damage to the tractor
electrical system.
 Protected Circuit
Fuse No. Capacity (A)
(1) 15
(2) 5
(3) 5
(4) 10
(5) 15
(6) 5
(7) 15
(8) 15
(9) 5
(10) 5
(11) 5
(12) 15
(13) 5
(14) 10
(15) 15
(18) 20
(16) Fuse Case
Slow Blow Fuse (ROPS Model)
1. The slow blow fuse are intended to protect the electrical cabling.
If any of them has blown out, be sure to pinpoint the cause.
Never use any substitute, use only a KUBOTA genuine part.
2. Remove the bolt from fuse box. (Bolt fixed slow blow fuse)
Pull out the fuse from the fuse box.(Non bolt fixed slow-blow
fuse)
3. Replace with a new one of the same capacity.
No. Capacity
(1) 60 A
(2) 50 A
(3) 40 A
(4) 30 A
(5) Fuse Box
(6) Bolt
8-S10
ELECTRICAL SYSTEM
Protected circuit
Work light
Meter (Backup)
ECU (Backup)
Turn Signal
Loader Plug
Meter Panel
Head Light
Flasher
Starter Relay
PTO, Engine
Transmission control
ECU
Spare Fuse
Spare Fuse
Spare Fuse
CRS Power
(17) Fuse Puller
9Y1210828ELS0010US0
Protected circuit
Charge
Bolt fixed
Engine preheat
Head lamp, Starter
Non Bolt fixed
Key switch, Work light
(7) Bolt Fixed Slow Blow Fuse
(8) Non Bolt Fixed Slow Blow Fuse
9Y1210828ELS0011US0
Type
KiSC issued 08, 2013 A