wsm M7060 Workshop Manual page 623

M6060, M7060, WSM
Control Rods, Brake Hoses and Levers
1. Disconnect the position control rod (2) and draft control rod (1).
2. Disconnect the brake hose (3) in both sides.
3. Disconnect the main gear shift lever (4).
4. Disconnect the range gear shift lever (5).
(When reassembling)
• Be sure to adjust the length of position control rod (2) and draft
control rod (1). (See page 7-S9.)
• Be sure to adjust the main gear lever (4). (See page 2-S11.)
• Be sure to adjust the range gear shift lever (5). (See page
2-S13.)
• Be sure to bleed the air from hydraulic brake line. (See page
4-S6.)
Rear wheel mounting nut
Tightening torque
Brake hose retaining nut
(1) Draft Control Rod
(2) Position Control Rod
(3) Brake Hose
Dismounting Cabin
1. Set the cabin dismounting tool (3) to the cabin. (See page
G-84.)
2. Remove the cabin mounting all screws (1) and nuts (2).
3. Dismounting the cabin from tractor body.
(When reassembling)
Cabin mounting screw and
Tightening torque
nut
(1) Cabin Mounting Screw
(2) Cabin Mounting Nut
9-S41
260 to 304 N·m
26.5 to 31.0 kgf·m
191.8 to 224.2 lbf·ft
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(4) Main Gear Shift Lever
(5) Range Gear Shift Lever
9Y1210828CAS0067US0
124 to 147 N·m
12.6 to 15.0 kgf·m
91.2 to 108 lbf·ft
(3) Cabin Dismounting Tool
9Y1210828CAS0068US0
KiSC issued 08, 2013 A
CABIN