Position And Draft Control Linkage - wsm M7060 Workshop Manual

M6060, M7060, WSM

[3] POSITION AND DRAFT CONTROL LINKAGE

Adjusting Position Control Rod and Draft Control Rod
1. Be sure to adjust the position control rod (1) length (L1) and
draft control rod (3) length (L2).
IMPORTANT
• Each draft control lever and position control lever should
contact with lever guide lowest position when operate the
position lever 1 (2) and draft lever 1 (4) to end of direction
(a).
If not, adjust the position control rod (1) length (L1) and/or
draft control rod (3) length (L2).
[ROPS Model]
Position control rod
Factory specification
length (L1)
Draft control rod length
Factory specification
(L2)
[CABIN Model]
Position control rod
Factory specification
length (L1)
Draft control rod length
Factory specification
(L2)
(1) Position Control Rod
(2) Position Lever 1
(3) Draft Control Rod
(4) Draft Lever 1
(5) Position Control Lever
(6) Draft Control Lever
7-S9
HYDRAULIC SYSTEM
Approx.
159 mm
6.26 in.
Approx.
146 mm
5.75 in.
Approx.
185 mm
7.28 in.
Approx.
179 mm
7.05 in.
[A] ROPS Model
[B] CABIN Model
L1 : Length of Position Control Rod
L2 : Length of Draft Control Rod
a : Direction for Lower
9Y1210828HYS0007US0
KiSC issued 08, 2013 A