wsm M7060 Workshop Manual page 394

M6060, M7060, WSM
Propeller Shaft
1. Slide the propeller shaft cover (3) after removing the screw (8).
2. Tap out the roll pins (2) and then slide the coupling (1) to the
rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (5) and pinion
shaft.
• Tap in the roll pins (2) as shown in figure.
(1) Coupling
(2) Roll Pin
(3) Propeller Shaft Cover
(4) Roll Pin
Front Wheel and Power Steering Hoses
1. Check the front axle and engine are securely mounted on the
disassembly stand.
2. Remove the front wheel.
3. Lift the front axle and remove the front wheels.
4. Disconnect the power steering hoses (1), (2).
(When reassembling)
Power steering hose
retaining nut
Tightening torque
Front wheel mounting nut
(M16)
(1) Power Steering Hose 1
5-S7
FRONT AXLE
(5) Propeller Shaft
(6) Cover
(7) Coupling
(8) Screw
9Y1210828ENS0023US0
23 to 27 N·m
2.3 to 2.8 kgf·m
17 to 20 lbf·ft
260 to 304 N·m
26.5 to 31.0 kgf·m
192 to 224 lbf·ft
(2) Power Steering Hose 2
9Y1210828FAS0009US0
KiSC issued 08, 2013 A