Damper Disc; Hydraulic Shuttle Clutch - wsm M7060 Workshop Manual

M6060, M7060, WSM

[6] DAMPER DISC

[7] HYDRAULIC SHUTTLE CLUTCH

Removing Damper Disc
1. Remove the damper disc (1).
(When reassembling)
• Direct the shorter end of the damper disc boss toward the
flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the spline.
Damper disc mounting
Tightening torque
screw
(1) Damper Disc
Shuttle Case Assembly
1. Remove the shuttle case mounting screws and nuts.
2. Remove the shuttle case assembly (1) by using M10 × Pitch
1.25 mm screws into holes (a) and guide screws (2).
(When reassembling)
• Be sure to fit the O-rings (3) and apply transmission fluid.
• The oil passage hole (b) is free from liquid gaskets.
• Apply liquid gaskets (Three Bond 1206C or equivalent) to joint
face of the shuttle case and clutch housing case.
Shuttle case mounting
Tightening torque
screw and nut
(1) Shuttle Case Assembly
(2) Guide Screw
(3) O-ring
2-S33
TRANSMISSION
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 lbf·ft
9Y1210828TRS0048US0
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 lbf·ft
(a) Threaded Hole
(b) Oil Passage Hole
9Y1210828TRS0049US0
KiSC issued 08, 2013 A