Recommended Cutter Operation; Setting The Backfeed - Avery Dennison Monarch Tabletop Printer 1 System Administrator Manual

Recommended Cutter Operation:

With
Printhead RFID
Density Supply
203 No
203 No
203 RFID is not supported with 203 dpi
203 RFID is not supported with 203 dpi
300* No
300* No
300* Yes
300* Yes
*
Contact Service to order replacement 300 dpi printheads (KST) for use with the cutter and
RFID supplies.
S e t t i n g t h e B a c k f e e d
Backfeed advances each printed label to the desired dispense position. Once that label is
removed, the next label to be printed is backed up underneath the printhead.
Select To
Off Disable backfeed.
On Enable backfeed. The printer moves the supply backwards before
printing. Use the Positioning menu to set the dispense position and the
backfeed distance.
2-6 System Administrator's Guide
With
Stacker
Attached Recommended Cut Modes
No 1, 2, 4 – Note: Cut Modes 3 and 5 may cause ribbon tearing
Yes 1, 2, 4 – Note: Cut Modes 3 and 5 may cause ribbon tearing
No 1, 2, 3, 4, 5
Yes 1, 2, 3, 4, 5
No 1, 2, 4
Yes 3, 5 – Note: Some RFID supplies may curl and cause a jam
(with cut mode 3). If this happens, use cut mode 1.