Table of Contents
Advertisement
Headlight flasher
You can flash the high beams by pulling the
lever gently toward you (2). The lights will
go back to normal when you let go. While the
high beam is on, you will see a blue light on
the instrument panel.
NOTE
You can flash the high beams by pulling the
lever toward you, even if the light switch is
off.
If you turn the lights off with the head lights
set to high-beam illumination, the headlights
are automatically returned to their low-beam
setting when the light switch is next turned
to the "
" position.
Welcome light
This function turns on the front side-marker
and parking lights for about 30 seconds after
the UNLOCK button on the remote control
transmitter is pressed when the combination
headlights and dimmer switch is in the "OFF"
or "AUTO" position (for vehicles equipped
with the automatic light control). On vehicles
equipped with the automatic light control
(except for vehicles equipped with LDW), the
welcome light function will operate only
when it is dark outside the vehicle.
N00550001209
NOTE
While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK button on the remote con-
trol transmitter.
• Turn the combination headlights and dim-
mer switch to the "
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
It is possible to modify functions as follows:
• The headlights can be set to come on in the
low beam setting.
• The welcome light function can be deacti-
vated.
I n f o r ma t i o n P r o v i d e d b y :
Combination headlights and dimmer switch
NOTE
For details, consult a Mitsubishi Motors
N00563201117
dealer.
On vehicles equipped with Mitsubishi Multi-
Communication System, screen operations
can be used to make the adjustment.
Refer to the separate owner's manual for
details.
Coming home light
This function turns on the headlights in the
low beam setting for about 30 seconds after
the ignition switch is turned to the "OFF" or
"LOCK" position or the operation mode is
put in OFF.
1. Turn the combination headlights and dim-
mer switch to the "OFF" or "AUTO"
position (for vehicles equipped with the
automatic light control).
2. Turn the ignition switch to the "OFF" or
" or "
" position.
"LOCK" position or put the operation
mode in OFF. Also, if a key was used to
start the engine, remove the key from the
ignition switch.
3. Within 60 seconds of turning the ignition
switch to the "OFF" or "LOCK" position
or putting the operation mode in OFF, pull
the turn signal lever toward you.
N00547301110
Features and controls
5-181
5
Advertisement
Chapters
Table of Contents
