Clearing The Programmed - Mitsubishi 2016 Outlander Manual

HomeLink® Wireless Control System (if so equipped)
5
The indicators will illuminate/blink in
response to the following conditions:
: Blinking : Illuminates
Garage door opener closing
Garage door opener closed
Out of range
Garage door opener opening
Garage door opener opened
Out of range
5-224 Features and controls
®
The HomeLink
ing to these messages at a range up to 820.2
feet (250 m) (open line of sight), but range
may be reduced by obstacles such as houses
or trees. You may have to slow your vehicle
speed to receive the CLOSED or OPENED
message feedback from the garage door
opener. If the unit is out of range before
receiving either the UP or DOWN message
from the door opener, both the UP and
DOWN indicators will flash red followed by
a continuous lit orange indicator in the direc-
tion the door was last moving.
Recall of the door state after initial feedback
is possible by simultaneously pressing either
®
HomeLink buttons 1 and 2 or buttons 2 and
3 for 2 seconds. The last recorded message
(orange)
will be displayed for 3 seconds, again follow-
ing the garage door status indication of the
(green)
figure above.

Clearing the programmed

(red)
information
(orange)
To erase programming from the 3 buttons
(individual buttons cannot be erased but can
(green)
be "reprogrammed" as outlined below), fol-
low the steps noted:
(red)
has the capability of listen-
N00585300023
I n f o r ma t i o n P r o v i d e d b y :
1. Press and hold the 2 outer HomeLink
buttons for at least 10 seconds. The indi-
cator will change from continuous yellow
to rapidly flashing green.
2. Release both buttons.
NOTE
 Do not hold for longer than 20 seconds.
®
3. HomeLink is now in the train (or learn-
ing) mode and can be programmed at any
time beginning with "Programming a new
®
HomeLink " step 1.
Reprogramming a single
®
HomeLink button
®
To reprogram a HomeLink button, complete
the following.
1. Press and hold the desired HomeLink
button. Do not release the button.
2. The indicator light will begin to slowly
flash orange after 20 seconds. The Home-
®
Link button can be released at this point.
Proceed with "Programming a new
®
HomeLink " step 2.
®
N00585400024
®