Air Cleaner Filter; Radiator Cap - Mitsubishi 2016 Outlander Manual

CAUTION
 The required concentration of anti-freeze dif-
fers depending on the expected ambient tem-
perature.
Above -31 °F (-35 °C): 50 % concentration
of anti-freeze
Below -31 °F (-35 °C): 60 % concentration
of anti-freeze
You can check the concentration level with a
gauge from an automotive supply store, or
your authorized Mitsubishi Motors dealer or
service station can check it for you.
 Do not use water to adjust the concentration
of coolant.
 Do not top off the tank with plain water only.
Water by itself boils at a lower temperature
and does not stop rust or freezing. If the
water freezes, it will damage your cooling
system. Do not use tapwater. It can cause
corrosion and rust.

Radiator cap

The radiator cap must be sealed tight to pre-
vent losing coolant, which may result in
engine damage. Only use a Mitsubishi
Motors Genuine Parts radiator cap, or an
approved equivalent.
WARNING
 Wait for the engine to cool down before
opening the radiator cap. Otherwise hot
steam or boiling coolant could spray up
from the radiator and scald you.
Points to remember
 Do not overfill the reserve tank.
 Your vehicle uses a special radiator cap
that stays sealed and lets the coolant flow
from the reserve tank back to the radiator
when the engine cools down. If you need
to change the cap, use the exact same
kind.
 Check the coolant freeze point in the radi-
ator with the proper gauge, and only when
it is safe. If you add antifreeze, the con-
tents of the reserve tank must be protected
against freezing.
 Keep the front of the radiator and con-
denser clean.
 If the engine coolant temperature does not
rise after the engine is warmed-up, take
your vehicle to an authorized Mitsubishi
Motors dealer or a repair facility of your
choice to have the thermostat checked,
and replaced if necessary.
I n f o r ma t i o n P r o v i d e d b y :

Air cleaner filter

Air cleaner filter
The air cleaner filter will get dirty and dusty
from use and not filter properly. Replace it
with a new filter using the schedule in the
"WARRANTY AND MAINTENANCE
MANUAL".
1. For 2.4 L models, remove the two clips
(A), then remove the Air duct (B).
2. For 2.4 L models, while holding down the
tab (C), pull out the connector (D).
Vehicle care and maintenance
N00937901494
9
9-9