Mitsubishi 2016 Outlander Manual page 186

Adaptive Cruise Control System (ACC) (if so equipped)
5
To resume the control
After the ACC control has been canceled with
the ACC turned on, the ACC control can be
resumed by pushing up and releasing the
"RES +" switch.
NOTE
 When any of the following conditions are
present, the ACC control cannot be resumed.
• When your vehicle speed is lower than
approximately 6 mph (10 km/h) or higher
than 110 mph (180 km/h).
• When your vehicle is driven at speeds
between approximately 6 mph (10 km/h)
and 25 mph (40 km/h) and the ACC is not
detecting a vehicle in front.
• When ASC is in the OFF position.
• While ABS, ASC or TCL is activated.
• When the selector lever is in positions other
than "D" (DRIVE) and "Ds" (DOWN-
SHIFT & SPORTY DRIVING).
• While the brake pedal is depressed.
5-110 Features and controls
NOTE
• While the parking brake is engaged.
• When the ACC system has judged that the
performance for detecting a front vehicle is
degraded.
• When an abnormality in the ACC system
has been detected.
To change the following dis-
tance
N00581800033
With the ACC turned on, the distance
between your vehicle and a vehicle ahead can
be selected from three levels by pushing the
ACC distance switch. Each time the ACC
distance switch is pushed, the following dis-
tance will change from "Long" to "Middle",
to "Short", and return to "Long" again.Every
time the ACC is turned to ON, the following
distance is reset to "Long".
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 Actual distance will vary depending on your
vehicle speed and the front vehicle speed.
The distance will become longer when the
vehicle speeds are higher.
The following distance indicator shows the
level of the following distance:
"Long"
N00581900021
"Middle"
"Short"
To activate conventional cruise
control
Press and hold the "ACC ON/OFF" switch
while the operation mode is in the "ON" posi-
tion. A buzzer will sound and the multi infor-
mation display will show the following
indicator.
N00582000029