Mitsubishi 2016 Outlander Manual page 212

Multi Information display - Type 1
Usage examples for trip odometer
odometer
It is possible to measure two currently
traveled distances, from home using
trip odometer and from a particular
point on the way using trip odometer
.
5
To reset the trip odometer
To return the display to 0, hold down the
multi information display switch for about 2
seconds or more. Only the currently dis-
played value will be reset.
Example
If trip odometer is displayed, only trip
odometer will be reset.
 Both trip odometers
count up to 9999.9 miles/kilometers.
When a trip odometer goes past 9999.9
miles/kilometers, it returns to 0.0 miles/
kilometers.
 When disconnecting the battery terminal,
the memories of trip odometer displays
and are cleared, and their displays
return to "0.0 miles/kilometers".
5-136 Features and controls
, trip Service reminder
Displays the approximate time until the next
recommended periodic inspection. "---" is
displayed when the inspection time has
arrived.
NOTE
 The service reminder time can be modified
by an authorized Mitsubishi Motors dealer,
to adjust for severe usage, etc. Refer to
"Severe maintenance schedule" in your vehi-
cle's Warranty and Maintenance Manual. For
further information, please contact your
authorized Mitsubishi Motors dealer.
and can
1. Shows the time until the next periodic
inspection.
N00556701237
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 Shows the distance in units of 100 miles (100
km) and the time in units of 1 month.
2. This informs you that a periodic inspec-
tion is due. Contact an authorized Mit-
subishi Motors dealer or a repair facility
of your choice to have the system
checked.
At that time, when the ignition switch is
switched from the "OFF" or "LOCK"
position to the "ON" position or the oper-
ation mode is changed from OFF to ON,
the warning display is displayed for a few
seconds on the information screen.
3. After your vehicle is inspected at an
authorized Mitsubishi Motors dealer, it
displays the time until the next periodic
inspection.
To reset
The "---" display can be reset while the igni-
tion switch or the operation mode is in OFF.