Mitsubishi 2016 Outlander Manual page 48

Seat belts
Driver's seat belt
reminder/warning light and
display
4
Type 1
Type 2
A tone and warning light are used to remind
the driver to fasten the seat belt.
If the ignition switch is turned to the "ON"
position or the operation mode is put in ON
without the driver's seat belt being fastened, a
4-22 Seat and restraint systems
warning light will come on and a tone will
sound for approximately 6 seconds to remind
you to fasten your seat belt.
If the vehicle is driven with the seat belt still
unfastened, the warning light will blink and
N00418401394
the tone will sound intermittently until the
seat belt is fastened. At the same time, "FAS-
TEN SEAT BELT" is displayed on the infor-
mation screen in the multi information
display (Type 1 only).
WARNING
 In order to reduce the risk of serious
injury or death in an accident, always fas-
ten your own seat belt. Do not allow any-
one to ride in your vehicle unless he or she
is also seated and fastening a seat belt.
Children should additionally be restrained
in a secure child restraint system.
NOTE
 If the seat belt subsequently remains unfas-
tened, the warning light and the tone will
issue further warnings each time the vehicle
starts moving from a stop.
I n f o r ma t i o n P r o v i d e d b y :
Front passenger seat belt warn-
ing light
The front passenger seat belt warning light is
located in the instrument panel.
When the ignition switch is turned to the
"ON" position or the operation mode is put in
ON, this indicator normally comes on and
goes off a few seconds later.
The light comes on when a person sits on the
front passenger seat but does not fasten the
seat belt. It goes off when the seat belt is sub-
sequently fastened.
N00418301247