Mitsubishi 2016 Outlander Manual page 182

Adaptive Cruise Control System (ACC) (if so equipped)
WARNING
• When a vehicle in front is a truck loaded
with freight that protrudes rearward
from the cargo bed.
• When the height of a vehicle in front is
extremely low or the road clearance of
the vehicle is extremely high.
5
• When driving on a road with alternating
up and down surfaces.
• When driving on a curve.
• When driving on a bumpy or rough road.
• When driving in a tunnel.
• When driving in construction zones.
• When the rear of your vehicle is weighed
down with the weight of passengers and
luggage
• For up to two minutes after starting driv-
ing.
• When driving in curved sections of road
including their entrance/outlet or run-
ning beside a closed lane in a traffic work
or similar zone.
• When the surface of the sensor is covered
with dirt, snow, ice, etc.
• When a front vehicle or an oncoming
vehicle is splashing water, snow or dirt.
5-106 Features and controls
WARNING
• When driving on a winding road.
 Never use the ACC in the following situa-
tions:
• In heavy traffic.
• On winding roads.
• On slippery roads, such as icy, snow-cov-
ered or dirt roads.
• In adverse weather conditions, such as
rain, snow or sand storms, etc.
• On steep downslopes.
• When the inclination of a road fre-
quently changes.
• When the approach alarm frequently
sounds.
• When your vehicle is towed or is towing
another vehicle.
• When your vehicle is on a chassis dyna-
mometer or free rollers.
• When tire inflation pressures are not
adequate.
• When the temporary spare tire is being
used.
• When the radar sensor and/or its sur-
rounding area are damaged or deformed.
I n f o r ma t i o n P r o v i d e d b y :
CAUTION
 To maintain proper performance of the ACC:
• Always clean the surface of the radar sen-
sor.
• Avoid impacting the radar sensor or its sur-
rounding area.
• Do not put a sticker on the radar sensor or
its surrounding area.
• Do not paint the radar sensor.
• Do not install a grill guard.
• Do not modify the radar sensor or its sur-
rounding area.
• Always use tires of the same size, same
type, and same brand, and which have no
significant wear differences.
• Do not modify the vehicle's suspension.
To increase the set speed
There are two ways to increase the set speed.
By using the "RES +" switch:
The set speed will increase by 1 mph (1
km/h) every time you push up the "RES +"
switch while the ACC is activated. If you
hold the switch pushed up, the set speed
increases in 5 mph (5 km/h) increments.
N00581500027