Headlight Leveling Switch (If So Equipped) - Mitsubishi 2016 Outlander Manual

Headlight leveling switch (if so equipped)

5
4. The headlights will come on in the low
beam setting for about 30 seconds. After
the headlights go off, the headlights can
be turned on again in the low beam setting
for about 30 seconds by pulling the turn
signal lever toward you within 60 seconds
of turning the ignition switch to the
"OFF" or "LOCK" position or putting the
operation mode in OFF. To turn on the
headlights again after 60 seconds of turn-
ing the ignition switch to the "OFF" or
"LOCK" position or putting the operation
mode in OFF, repeat the process from step
1.
NOTE
 While the coming home light function is
operating, perform one of the following
operations to cancel the function.
• Pull the turn signal lever toward you.
5-182 Features and controls
NOTE
• Turn the combination headlights and dim-
mer switch to the " " or "
or put the operation mode in ON.
• Turn the ignition switch to the "ON" posi-
tion or put the operation mode in ON.
 It is possible to modify functions as follows:
• The time that the headlights remain on can
be changed.
• The coming home light function can be
deactivated.
For details, consult a Mitsubishi Motors
dealer.
On vehicles equipped with Mitsubishi Multi-
Communication System, screen operations
can be used to make the adjustment.
Refer to separate owner's manual for details.
Headlight leveling switch
so equipped)
The direction of the headlight beam (the
direction in which the light shines) alters
according to the number of people and the
load in the vehicle. Lower the headlight angle
if it is too high due to the number of people
and/or the load in the vehicle so that the head-
lights' glare does not distract the drivers of
approaching vehicles. First set the light
switch to the " " position, then turn the
headlight leveling switch knob to lower the
I n f o r ma t i o n P r o v i d e d b y :
beam. The greater the number on the head-
light leveling switch knob, the lower the
beam will point.
" position
Set the switch to the appropriate position so
that the headlight beam is level with the road.
WARNING
(if
 To avoid distraction while driving, always
perform headlight adjustments before
vehicle operation.
N00537101115
NOTE
 Start adjusting when the knob is at the "0"
position (when the beam is at its highest).
 Keep the knob in the "0" position except
when using the knob to lower the headlight
beam angle.
 Always return the knob to the "0" position
when the load is removed and the people
have left the vehicle.