Mitsubishi 2016 Outlander Manual page 434

Replacement of light bulbs
2. Remove the screws (A), and then move
the light unit toward the rear of the vehi-
cle to unfix the notch (B) and pins (C).
9
9-36 Vehicle care and maintenance
3. Turn the socket counterclockwise and
remove it, and then pull the bulb out of
the socket.
D- Rear turn signal light
E- Tail light and stop light (LED) - cannot
be replaced
NOTE
 The rear side-marker light, tail light and stop
light use an LED instead of the bulb.
Check with an authorized Mitsubishi Motors
dealer or a repair facility of your choice
when the light needs to be repaired or
replaced.
4. To install the bulb, perform the removal
steps in reverse.
I n f o r ma t i o n P r o v i d e d b y :
NOTE
 When mounting the light unit, align the
notch (F) and pin (G) on the light unit with
the clip (H) and hole (I) in the body.
Back-up lights
1. Push the light unit upward to remove it.
NOTE
 Wrap a cloth around the tip of the screw-
driver to keep from scratching the lens.
N00929101080