Table of Contents
Advertisement
NOTE
It is possible to activate the following func-
tions:
• Flashing of the turn-signal lamps when the
lever is operated with the operation mode
of the power switch is in ACC.
• The turn-signal lamps 3-flash function for
lane changes can be deactivated.
• The time required to operate the lever for
the 3-flash function can be adjusted.
For further information, please contact an
authorised MITSUBISHI MOTORS dealer.
It is possible to change the tone of a sound-
ing buzzer as the turn-signal lamps flash.
Refer to "Changing the turn-signal sound"
on page 5-12.
Hazard warning flasher
switch
Use the hazard warning flasher switch when
the vehicle has to be parked on the road for
any emergency.
The hazard warning flashers can always be
operated, regardless of the operation mode of
the power switch.
Press the switch to turn on the hazard warn-
ing flashers, all turn-signal lamps flash con-
tinuously.
To turn them off, press the switch again.
NOTE
While the hazard warning lamps are blinking
due to having manually pressed the switch,
the emergency stop signal system does not
operate. Refer to "Emergency stop signal
system" on page 6-33.
Front fog lamp switch
E00506602734
The front fog lamps can be operated while the
headlamps or tail lamps are on. Turn the knob
in the "ON" direction to turn on the front fog
lamps. An indicator display in the 8 inch digi-
tal driver display will also come on. Turn the
knob in the "OFF" direction to turn off the
front fog lamps. The knob will automatically
return to its original position when you
release it.
Hazard warning flasher switch
NOTE
The front fog lamps are automatically turned
off when the headlamps or tail lamps are
turned off. To turn the front fog lamps on
again, turn the knob in the "ON" direction
after turning on the headlamps or tail lamps.
Do not use fog lamps except in conditions of
fog, otherwise excessive lamp glare may
temporarily blind oncoming vehicle drivers.
E00506802257
Wiper and washer switch
The windscreen wipers and washer can be
operated with the operation mode of the
power switch in ON or ACC.
If the blades are frozen to the windscreen or
rear window, do not operate the wipers until
the ice has melted and the blades are freed,
otherwise the wiper motor may be damaged.
Instruments and controls
5
E00507102954
5-47
Advertisement
Chapters
Table of Contents
