Mitsubishi 2016 Outlander Manual page 341

NOTE
 Set the temperature at about 75 (when the
outside temperature unit of the multi-infor-
mation display shows °F) or 24 (when the
outside temperature unit of the multi-infor-
mation display shows °C) under normal con-
ditions.
 When the engine coolant temperature is low,
the air temperature from the heater will be
cool/cold until the engine warms up, even if
you have selected warm air with the temper-
ature switch. To prevent the windshield and
windows from fogging up, the vent mode
will be changed to " " and the blower
speed will be reduced.
Operating the air conditioning
system (manual mode)
Blower speed and vent mode may be con-
trolled manually by setting the blower speed
selection switch and the MODE switch to the
desired positions. To return to automatic
operation, press the AUTO switch.
Defrosting or defogging (wind-
shield, door windows)
CAUTION
 For safety, make sure you have a clear view
through all the windows.
To remove frost or mist from the windshield
and door windows, use the MODE switch or
defogger switch ("
 For ordinary defrosting
Use this setting to keep the windshield and
door windows clear of mist, and to keep the
leg area heated (when driving in rain or
snow).
N00731801125
I n f o r ma t i o n P r o v i d e d b y :
Automatic climate control air conditioner
Type 1
N00732401506
Type 2
" or " ").
1. Set the air selection switch to the outside
position.
2. Set the MODE switch to the "
tion.
3. Select your desired blower speed by
pressing the blower speed selection
switch.
4. Select your desired temperature by press-
ing the temperature control switch.
5. Push the air conditioning switch.
" posi-
Comfort controls 7-13
7